Panasonic EY3530NQMKW - Manual (Page 16)

Installing Blade
Follow these steps:
1. Remove the battery pack from the metal
cutter.
2. Remove any cutting debris from blade area.
3. Use the lower guard lift lever to retract
(open) the lower guard.
4.lnstall the blade as Illustrated in Fig. 13
(page 16). Make sure that both the direction
arrow on the blade and the direction arrow
on the upper blade cover point in the same
direction.
5. Set the outer washer in place.
6. Insert the hex bolt.
7. Hold the shaft lock button dowa This preverá
the blade from rotating.
6. Tighten the hex boN secmely with the provided
hex wrench. Store the hex wrench.
CAUTION
Keep the hex mench In the storage slot on
the metal cutter's body when not using it
WARNING
Failure to follow these instructions can
result in severe personal injury.
For Appropriate use of
Battery pack
Ni-MH Baneiy pack (EY9230)
• Charge the Ni-MH battery fully before storage
in order to ensure a longer service life.
• The ambient temperature range is between
0*Cand40‘C.
If the battery pack is used when the battery
temperatuiB is below 0*C, the toot may fail to
function property. In that, charge the battery
until charging is completed for impropriate
functioning of the battery.
Battery Pack Life
The rechargeable batteries have a Irniled Ufa. If the
operation time becomes extremely short after
rschatging, replacs ttie battery peck witti a new one.
Note: • Ute under arttrernely hot or cold oorxftions
will reduce operating capacity per
charge.
NOTE
Even if you don’t use the Metal Cutter,
charge the battery pack at least once every
six months.
Cleaning Metal Cutter
Keep your metal cutter clean for good cutting
performance and to help keep it safe to use.
follow these steps:
1. Remove the battery pack from the metal
cutter.
2. Wipe the metal cutter with a dry, soft cloth.
Do not use a wet cloth or cleaning liquids.
They could damage the metal cutter’s finish.
3. Be sure to rub off any oil or grease which
could make the metal cutter sli|m0ry or hard
to harxile.
4. Remove the blade and brush off any dust.
CAUTION
To avoid injury or damage to the unit, never
immerse any part of №e tool in a Hqiid.
Transparent Window
WARNING
If the window is cracked, or is broken, take
the metal cutter to an authorized service
center for replacement. Do not attempt to
operate cutter. It could result in serious
personal injury.
Never use your metal cutter with a damaged
transparent window or without the transparent
window installed. Flying ch^ could result in
serious injury.
Accessories
WARNING
* The use of any accessories not specified in
this manual may result in fire, electric
shock, or personal injury. Use recom­
mended accessories only.
* Use of a blade on material that is thickBr or
thinner than that recommended for that
blade will result in a rough cut, and could
increase the risk (rf "kick back*or other hjury.
Blade for metal material
• EY9PM13C
For cutting unhardened ferrous material
Thickness of material
0.5mm-6.0mm(1/32"-1/4*)
Blade for cutting thin metal material
• EY9PW13B
For cutting unhardened ferrous materisd
Thickness of material
0.5mm-6.0mm(1/32“-1/4'')
— 17 —