Panasonic EY3530NQMKW - Manual (Page 11)

Using Metal Cutter
CAUTION
R«ad the ^Seneral and Specific Safety
Rules” at the front of this manual before
using the metal cutter.
Follow ttiese steps;
Hold the metal cutter with both hands, as
shown in R q . 4, Do not attempt to remove cut
material when Made is moving.
1. Une up the center of the notch with your
cuttirtg line.
2. Press the switch lock lever down, then
squeeze the power switch to start the
motor,
CAUTION
• Check that the switch lock lever works.
If power switch can be activated without
depressktg the switch lock lever, discon­
tinue use immediately. Take the toot to
an authorized service center.
• Always hold the handle with one hand
and the front grip with the other. (See Fig.
4. page 12) Maintain a firm grip and
depress the switch fuKy.
• The blade should not touch the cutting
material before you start the motor. Wait
untit the Made reaches full speed before
starting a cut
CAUTION
This tool has no provision to lock the switch
in the ”ON* position, and you must not
attempt to secure it in the "ON” position.
3. Start cutting when the blade reaches full
speed.
4. During cutting, keep your cutting line
straight. Move the metal cutter forward at a
steady speed, while looking at the tip of the
blade through the transparent window.
WARNING
• To prevent dangerous kickback, keep the
base of the metal cutter flat on the auriaoe
of the material being cuL
• Never force the cutter. Use light and continuous
pressure.
5. If the motor starts to feet too warm, stop
cutting. Let the metal cutter cool down
before continuing work.
6. It is always a safe practice to remove the
battery pack after use and before storing
the metal cutter.
—
12
—