Citizen Systems CLP 6002 - Manual (Page 18)

E
N
G
L
I
S
H
3.3 Ribbon Installation (CLP 7201e, 7202e)
CAUTION Be careful of the edges of the plates so injury or
property damage is possible.
After opening the cover, install the ribbon as follows:
1 Push down the head open lever to move the print
head out of the way.
2 Insert the ribbon shaft in the roll ribbon so
that it is in its deepest position.
3 Set it in the ribbon holder as shown in the
figure.
4 Pull the ribbon from under the transfer
mechanism to the ribbon winding side.
5 Insert the ribbon shaft in the paper core so that it
is in its deepest position. Then set it in the
ribbon winder as shown in the figure.
6 Stick the top end of the ribbon to the paper core
with adhesive tape. Turn the ribbon winder in
the direction ribbon winding to remove slackness
and wrinkles from the ribbon.
NOTE: the CLP 7201e and CLP 7202e destination (used) ribbon winds in the
opposite direction to the CLP 1001, 2001 and 6000 series.
7 Close the mechanism and press down the green plastic to lock the
mechanism, then close the cover.
8 Turn on the power to the printer. The LCD screen on the control panel will
display "On line." Press the Feed key. The paper will advance to the next
label and stop there.
For specialist ribbons, adjustments to the auto-tensioning system may be necessary.
Please refer to section 3.7 for more details.