Citizen Systems CLP 6002 - Manual (Page 14)

E
N
G
L
I
S
H
2.4 Self-Test Mode And Hex Dump
The printer enters the self-test
mode when the Feed key is
pressed and held down while
turning the printer on.
If the Feed key is held down
for more than four seconds,
the printer assumes
continuous media is installed.
The printer performs a
two-page self-test print then
enters the Hex Dump or Data
Dump mode (prints out the
communication data by ASCII
code).
The printer returns to the
normal operating mode only
when the power is turned off.
2.5 System Maintenance Mode
The printer enters the system maintenance mode when the Pause, Feed and
Stop keys are pressed and held down simultaneously while turning the printer on.
The printer enters the communication parameter setting, system setups and
paper gap and black line sensor sensitivity adjusting mode.
The mode is selected with the Pause key and the mode item is selected with the
Feed key. Changing of the contents is executed as soon as they are displayed
on the screen. Pressing the Stop key returns the printer to the normal operating
mode.
LCD Indication
Function Description
Select baud rate between 38,400
bps down to 300 bps.
Select 8 or 7 data bits
Select Native Off or Native On
mode.
Select distance of media sensor
relative to the printhead position.
Select between standard command
set, AS400 mode or raster mode.
Select between fixed media and
adjustable sensor when installed.
See through or black line sensor
checking mode. See Section 2.6
9600bps 19200bps
8 bits 7 bits
NativeOF NativeON
fVirtual fReal
Cmnd STD Cmnd AS4 Cmnd RST
38400bps
PE x.xxV BL x.xxV
AjSensOF AjSensOn