Citizen Systems CLP 6002 - Manual (Page 15)

E
N
G
L
I
S
H
PE 3.05v
S/I Init
S Maint
BL 3.05v
2.6 Adjusting the sensors for different media
The voltage setting mode, part of the system setting mode, is used to correctly
adjust the see-through or black line sensors for the particular type of media being
used in the printer. The ideal voltage is between 3.0v and 3.3v for both the PE
(paper end or gap) and BL (black line) modes.
Adjustment procedure for label paper (with label gap):
1 Remove a label from the backing paper (liner) and set the liner ONLY under
the media sensor (see section 3.4).
2 Adjust the paper gap value on the control panel to a value
between 3.0 volts and 3.3 volts. Adjustment is made using
the upper adjuster on the control panel. See section 2.1
Adjustment procedure for media with a black line on the reverse side:
1 Set the unmarked part of the media – the area without the black line - under
the media sensor (see section 3.4).
2 Adjust the black line value on the control panel to a value
between 3.0 volts and 3.3 volts. Adjustment is made using
the middle adjuster on the control panel. See section 2.1
2.6 Factory Default Settings
To return the print to Factory Default settings, press and hold down the Pause,
Feed and Stop keys simultaneously for more than four seconds whilst turning on
the power.
The display will first show “S Maint”
You must keep the buttons held down until the LCD displays the
message “S/I Init”