Kofax Ascen 7.5 Release Script for FileNet Content Manager 4.5 - Manual (Page 15)

Ascent® 7.5 Release Script for FileNet Content Manager 4.5 Release Notes
Kofax, Inc. 9
Additional Information
This section contains additional information about the Ascent® 7.5 Release Script for FileNet
Content Manager 4.5.
Binary and Object Properties Not Supported
The Ascent® 7.5 Release Script for FileNet Content Manager 4.5 does not support document
classes or folder classes that contain the Binary or Object properties. Note the following:
„
If Binary and/or Object properties are not required and are part of the selected document
or folder class, the properties will be hidden.
„
If Binary and/or Object properties are required and are part of the selected document or
folder class, you will receive an error message at release setup when you attempt to select
the document or folder class. In addition, you will not be able to select the document or
folder class.
Viewing FileNet Content Manager Data in Release Setup
All FileNet Content Manager information is refreshed in release setup when you log in to the
release script. This includes the available object stores, document classes, document properties,
folder classes, folder properties, and existing folders. Also, whenever you select an object store in
release setup, available document classes, folder classes, and existing folders are refreshed. In
addition, whenever you select a class in release setup, the document and folder properties are
refreshed. However, if document or folder properties are modified in FileNet Content Manager
after the first time a class is selected, you must log out of the release script and log back in to see
the latest properties.
Skip First Page
The “Skip first page of each document” option as specified on the General Settings tab, allows you
to discard the first page of each document from the image. However, if you are releasing only one
image in a document and you select this option, release will fail and the document will be routed
to the Ascent Capture Quality Control module.
{Index Operator’s Station ID} Ascent Capture Value
The Ascent Capture Value {Index Operator’s Station ID} has been deprecated, and replaced by
{Validation Operator’s Station ID}. It is strongly recommended that you use {Validation
Operator’s Station ID} instead.