Kofax Ascen 7.5 Release Script for FileNet Content Manager 4.5 - Manual (Page 10)

Ascent® 7.5 Release Script for FileNet Content Manager 4.5 Release Notes
4 Kofax, Inc.
Kofax.P8Rel45_V75.ConnectorInterfaceFactory.dll
Kofax.P8Rel45_V75.ConnectorInterfaceFactory.tlb
When you are prompted to replace the existing files, select “Yes.”
4 Register the Kofax.P8Rel45_V75.ConnectorInterface.dll and the
Kofax.P8Rel45_V75.ConnectorInterfaceFactory.dll by invoking the regasm command in
the command line prompt. The command to register these dll’s is:
regasm.exe [InstallDir]\ /codebase /tlb
For example:
regasm.exe C:\Program
Files\Ascent\CAP\P8Rel45_V75\Kofax.P8Rel45_V75.ConnectorInterface.dll /codebase
/tlb
Note regasm.exe is located in C:\Windows\Microsoft.NET\Framework\v1.1.4322\. To
run this executable, you can navigate to this folder and run it or place this path in the Path
environment variable and run it from any location.
5
Re-compile the release script using steps 2 through 4 in the “To modify the release script”
section above. These steps ensure that the release script references the newly registered
connector interface and connector interface factory.
Note Make sure that the project references the two .tlb files.
Note To successfully modify and compile the connector, connector interface, or connector
interface factory, development must occur on a workstation with Microsoft WSE 2.0 SP3
(development setup).