Kistler-Morse KM InvisiLink - Manual (Page 9)

www.kistlermorse.com
5
97-1502-13 Rev. C
Holes should be made in the front 2 inches of the bottom of the enclosure (Figure 1); this
allows for appropriate spacing for cables.
5. Clean enclosure of any debris, replace the board back into the enclosure, using all four (4)
mounting screws.
6. Determine desired location for mounting the unit.
TO MOUNT THE INVISILINK ENCLOSURE
1. Hold the enclosure against the wall in the desired location and mark the positions of the
mounting holes. Place the enclosure in a safe location.
2. Drill the mounting holes in the wall.
3. Attach the enclosure to the wall using hardware that will secure it firmly in place.
TO MOUNT THE EXTENDED RANGE ANTENNA
The extended range antenna can either be mounted with the attached plate or with U-bolts, both
included as standard. The cable between the radio and the antenna is 6 ft (1.8 m) in length; plan the
location of the unit and antenna accordingly.
If using the plate, pre-drill holes in desired location and bolt to structure.
If using the U-bolts, determine location on pipe or pole to mount the antenna and attach with
mounting hardware.