Hangar 9 Piper Pawnee 40 ARF - Manual (Page 45)

45
Required Parts
• Fuselage assembly • Cowling
• 1/4-inch (4mm) tubing (4) • #4 washer (4)
• Spinner w/hardware
• Canopy
• Pilot seat
• 4-40 x 1/2-inch socket head screws
Required Tools and Adhesives
• Hex wrench: 3/32-inch • Canopy glue
• Phillips screwdriver: #1 • Medium CA
• Hobby scissors • Low-tack tape
• Rotary tool w/sanding drum
 Step 1
Slide a #4 washer onto each of the four 4-40 x 1/2-inch
cowl mounting screws. A piece of 1/4-inch tubing is then
slid onto each of the screws.
 Step 2
Secure the cowling to the fuselage using the screws
prepared in the previous step.
 Step 3
Use the instructions provided with your engine to install
the spinner. The spinner cone is attached to the spinner
backplate using two 3mm x 12mm sheet metal screws and
a #1 Phillips screwdriver.
Section 10: Cowling and Canopy Installation