FRITSCH PULVERISETTE 15 - Manual (Page 31)

9.1.1 Assembling the rotating knives
NOTICE!
In order to turn or install the rotating knives, all 3 fixed
knives have to be pushed toward the exterior, and then the
gap has to be redefined. (see Ä ‘Assembling the rotating
knives’ on page 31 and Ä ‘Setting the gap width’
on page 23)
To remove the rotating knives, proceed as follows:
1.
Open the closing lid.
2. Open the upper half of the device.
3. The rotating knives are then completely accessible.
To fasten the rotor, wedge a piece of wood or similar
material between the rotating knife and the left fixed
knife.
4. The fastening screws of the rotating knives can be unscrewed with
a 6 mm Allen wrench.
5. Align one knife parallel to the edge of the rotor, push it toward the
fixed knife and screw it on.
6. Align the remaining rotating knives in the same way and screw
them on firmly.
9.1.2 Assembling the fixed knives
To remove the fixed knives, proceed as follows:
Maintenance
- 31 -