FRITSCH PULVERISETTE 15 - Manual (Page 28)

8 Cleaning
DANGER!
Mains voltage!
– Before beginning with cleaning work, disconnect the
mains plug and protect the device against being unin-
tentionally switched back on!
– Do not allow any liquids to flow into the device.
– Indicate cleaning work with warning signs.
– Put safety equipment back into operation after
cleaning work.
CAUTION!
Risk of injury due to sharp knives.
The housing of the cutting mill can be rubbed down with a damp cloth.
8.1 Cutting chamber
CAUTION!
Beware of dust exposure caused by cleaning with com-
pressed air!
Wear protective goggles!
n Open the closing lid.
n Position the rotor knives vertically.
n Flip open the upper part of the housing.
n Remove the sieve.
It is recommended to clean the cutting chamber with a vacuum cleaner
and a brush or with compressed air.
Any stuck material, due to e.g. residual moisture in the sample, can be
cleaned with alcohol.
Cleaning
- 28 -