FRITSCH PULVERISETTE 15 - Manual (Page 13)

NOTICE!
Immediately replace damaged or illegible information signs.
n Unauthorised alteration of the PULVERISETTE 15 will void Fritsch's
declaration of conformity to European directives and void the guar-
antee.
n Only use the PULVERISETTE 15 when it is in proper working order, as
intended and in a safety- and hazard-conscious manner adhering to
the operating manual. In particular, immediately rectify any malfunc-
tions that could pose a safety hazard.
n If, after reading the operating manual, there are still questions or
problems, please do not hesitate to contact our specialised per-
sonnel.
2.6 Protective equipment
Protective equipment is to be used as intended and may not
be disabled or removed.
All protective equipment is to be regularly checked for
integrity and proper functioning.
The cutting mill has a comprehensive safety system:
1.
A safety switch monitors the closing of the closing lid during oper-
ation and prevents the cutting mill from starting up when the lid is
open.
2. There is a safety switch for monitoring the collecting vessel.
During operation, it monitors the position of the collecting vessel
for the material to be cut (3.5 l pot or 30 l container) and prevents
the mill from starting up when the container has been removed.
n Both switches fulfil the directives concerning personal protection.
n The cutting mill cannot be started when the closing lid is open or the
collecting vessel has been removed.
n The cutting mill stops when the closing lid is opened and the col-
lecting vessel is unlocked.
Safety information and use
- 13 -