FRITSCH PULVERISETTE 15 - Manual (Page 14)

2.7 Hazardous points
n Crushing hazard when opening and closing the closing lid.
n Crushing hazard when opening or closing the upper half of the
housing.
n Risk of injury on sharp knives.
n Crushing hazard at the funnel lid.
n Crushing hazard when unclamping and clamping the collecting
vessel.
2.8 Electrical safety
2.8.1 General information
Turning the main switch to Stop (0) switches off the motor. The mill
comes to a standstill within seconds.
n The collecting vessel can be removed.
n The closing lid can be opened.
2.8.2 Protection against restart
The device shuts down if there is a power outage during operation. The
mill comes to a standstill within seconds.
n The collecting vessel can be removed.
When electrical power returns, the cutting mill does not start up. The
mill is secured against restarting.
Turning the switch to Start (I) switches on the motor, and the mill starts
to work.
2.8.3 Overload protection
A motor protection switch turns the device off if there is an overload.
(The rotary switch returns to "0").
Safety information and use
- 14 -