FRITSCH PULVERISETTE 15 - Manual (Page 18)

CAUTION!
Ensure that the device is safely fastened. Considerable lat-
eral forces can occur!
CAUTION!
The weight of the cutting mill is approx. 42 kg with cutting
tools.
NOTICE!
Place the cutting mill on a flat, stable surface. It may be
screwed to this or a base plate.
NOTICE!
– Make sure that the cutting mill is easily accessible. On
the right of the mill, there must be enough space to
open the upper part of the housing together with the
funnel.
– Make sure the ventilation grate on the back is not
obstructed. Risk of overheating!
1. The cutting mill is screwed to the transport palette using 4 screws.
Remove the 4 screws.
2. Lift the cutting mill from the transport pallet with 2 persons.
3. Assemble the device on a table or a stand:
n Place the cutting mill on a sturdy table and connect the motor
base to the tabletop using 4 screws so that the container
flange extends beyond the edge of the table.
n Or screw the cutting mill onto the stand which is available as
an accessory. For this purpose, refer to the assembly instruc-
tions included with the universal stand.
n Close the cutting chamber.
n Attach the collecting vessel.
Installation
- 18 -