FRITSCH PULVERISETTE 4 classic line - Manual (Page 23)

5 Initial start-up
Perform initial start-up only after all work as described in Ä Chapter 4
‘Installation’ on page 18 has been carried out.
5.1 Switching on
n Connect the device to the grid
n Switch the device on at the main switch (I ON)
5.2 Function check
n Open the hood.
n Take out any grinding bowl clamping devices and wood - the
grinding bowl holder must be completely empty - and close the
hood.
n Hold down the Program button until "1" appears on the LED display.
(In the delivery condition only memory location 1 has been allocated
a low motor speed).
n Press START button.
n The hood is locked and the mill runs at the programmed speed.
5.3 Switching off
n Press the STOP button.
n After a short time, once the mill is at standstill, the hood is unlocked
and can be opened.
Initial start-up
- 23 -