Elektron Analog Four - Manual (Page 59)

GLOBAL MENU
51
DELETE ENTRY deletes the whole entry. Select and reconfirm by pressing
[YES/SAVE].
INSERT BEFORE will create a new entry with a range ending on the note
preceding the current entry. Select by pressing [YES/SAVE].
INSERT AFTER will create a new entry with a range beginning on the note suc-
ceeding the current entry. Select by pressing [YES/SAVE].
• NONE sets a keyboard key or range that will not be used for any function. Convenient
for defining a ‘no-play’ zone on the keyboard between two or more sections with differ-
ent Sounds or functions.
RANGE LOW sets the note on the keyboard on which to start the desired key-
board range.
RANGE HIGH sets the note on the keyboard on which to end the desired key-
board range.
DELETE ENTRY deletes the whole entry. Select and confirm by pressing [YES/
SAVE].
INSERT BEFORE will create a new entry with a range ending on the note
preceding the current entry. Select by pressing [YES/SAVE].
INSERT AFTER will create a new entry with a range beginning on the note suc-
ceeding the current entry. Select by pressing [YES/SAVE].
• PAT.PLAY maps a chosen pattern to a specific MIDI keyboard key or range.
RANGE LOW sets the note on the keyboard on which to start the desired key-
board range.
RANGE HIGH sets the note on the keyboard on which to end the desired key-
board range.
PATTERN selects which pattern A01 - H16 of the active project will be played
when pressing a keyboard key in the range specified above. Set to CUR if the
current pattern is to be played.
PATTERN INC selects the increment with which the pattern will increase for
each successive key press in the specified range. For example, if set to 1, each
successive key will start pattern A01, A02, A03 and so on. Set to 2 it will play
pattern A01, A03, A05 et cetera. Set to 0 if the same pattern as set in PATTERN
above is to be played for every key in the range.
TRANSPOSE transposes the pattern up or down 1-36 octaves. No transpose if
set to 0.
TRANSPOSE INC sets the increment by which the transpose will be increased
for each step of the chosen keyboard range. No increase if set to 0.
CHG MODE sets the mode of starting the pattern. D.START starts the selected
pattern directly from its first step. D.JUMP starts the selected pattern on the
step following the current sequencer step. SEQ. starts the pattern from its first
step once the current pattern has reached its final step.
DELETE ENTRY deletes the whole entry. Select and confirm by pressing [YES/
SAVE].