ChemoMetec YC-100 - Manual (Page 37)

5 Operation of the NucleoCounter
25
elevated signal levels. If the number of pixels is above a predefined limit then the
cassette insertion slit can be contaminated with an interfering particle, like a dust
particle. An error message is shown in the display and a cleaning of the insertion slit is
recommended (refer to chapter 7 Maintenance of NucleoCounter).
If a PC with NucleoView is connected to the instrument a contaminant is usually
observed as an object, which is stationary in all images.
To initiate a Zero Count Check type in “F50 + ↵ ↵ ↵ ↵ ”. Then the following text will appear in
the display:
0 count check 0 count check 0 count check 0 count check
↵ ↵ ↵ ↵ Continue Continue Continue Continue
Esc Ab Esc Ab Esc Ab Esc Abort ort ort ort
Figure 20 Zero Count Check, step 1
Press “↵ ↵ ↵ ↵ ” to continue. Now the instrument prompts you to remove any cassette from
the insertion slit:
Remove any Remove any Remove any Remove any
cassette cassette cassette cassette
↵ ↵ ↵ ↵ Continue Continue Continue Continue
Esc Abort Esc Abort Esc Abort Esc Abort
Figure 21 Zero Count Check, step 2
Press “↵ ↵ ↵ ↵ ” to continue. Now the instrument prompts you to close the lid in order to avoid
false light from entering the insertion slit during the Zero Count Check:
Close lid Close lid Close lid Close lid
↵ ↵ ↵ ↵ Continue Continue Continue Continue
Esc Abort Esc Abort Esc Abort Esc Abort
Figure 22 Zero Count Check, step 3
Press “↵ ↵ ↵ ↵ ” to continue. Then a “Wait” message appears in the display:
wait... wait... wait... wait...
Figure 23 Zero Count Check, step 3A