Checkline PM4 - Manual (Page 6)

 Electromatic Equipment Co., Inc
-6-
9.0 MENU LEVEL OVERVIEW
Next calibration curve
Previous calibration curve
Power off (3 sec.)
Watch last saved data
Save new value
Power off (3 sec.)
Type selection menu
Store menu
Main menu
Switch upper
Switch lower
Open this menu / Enter
Keypad symbols
Measuring window:
Rolling Menu
Power ON / OFF
Switch upper
Switch lower
Save
Hold
Watch saved
data
Add supplier’s
data
Menu:
Enter
Switch upper
Switch lower
Back
Enter numbers
Enter letters
Next or right
Left
Yes
No
Shift
OK
Data storage
Manual logs
Auto logs
Clear logs
Print logs
Last logs
All logs
Clear logs
Send logs
Manual Logs
Auto logs
Clear Logs
Options
Options
Date / Time
Log Time
Language
Unlock
°C / °F
Calibrate
o Userlevel
BL On Time
Auto Off Time
Materialcalib.
Password
Reset
SN.
Logo
TM
Admin
Overview main menu
 Electromatic Equipment Co., Inc
-11-
15.0 PRINT SAVED DATA (LOGS)
To print your saved data, connect the device to the printer
using the printer cable that was delivered with your
device. Carefully loose the protection cap on the
humimeter PM3. At first plug in the side of the connector
with the close plastic casing at the humimeter PM3. Then
switch on the device.
Not till then the other side of the cable has to be plugged
in at the printer. Switch on the printer by pressing . Now
the green LED is blinking. If it does not blink, please
change the batteries and try again.
Press the button at your humimeter until you reach the
menu (see image on the right). Select „Print Logs“ and
confirm by pressing .
Now you can select if you want to print the last saved
measuring series or all saved measuring series (logs).
Confirm by pressing
again. The selected logs are
printed out now.
To save paper, please think of clearing the data storage
regularly.
Emission ratio
The infrared temperature measurement depends on the
emission ratio of the measured product. By default, the
humimeter PM4 contains the emission ratio of paper
(0.950). For changing this value, please proceed as
follows:
Press the key as long as you reach the main menu.
Choose the menu item “Options” and confirm by pressing
. Then choose the item “emission ratio” and confirm
with again.