Checkline MCT-HS User Manual

Page 7



Electromatic Equipment Co., Inc.

-10-

100

−

13.0 CHANGING BATTERIES

If the batteries are empty, please change them as follows:

1 Press with your finger onto the arrow of the battery cap

and pull it back.

2. Remove the empty batteries.
3. Put four new 1,5 Volt AA Alkaline batteries into the

device. Make sure that the position of the battery poles
is correct.

4. Press down the batteries and close the cap.

If the battery symbol appears in the measuring window resp.
if a critical charge of battery is shown in the status, the
batteries have to be changed IMMEDIATELY. If you do not
use your MCT-HS-PRO device for a longer period, remove
the batteries. For eventual resulting damages we cannot
provide any warranty.

14.0 DETERMINATION OF THE MATERIAL REFERENCE MOISTURE

The MCT-HS-PRO determines the water content, that means that it calculates the
moisture referred to the total mass:

: Mass with average moisture content

: Mass of the dried sample

%F: Calculated absolute moisture

(water content) (according to norm:
CEN/TS 14774)



Electromatic Equipment Co., Inc.

-7-

9.0

CHANGING THE USER LEVEL

Changing from advanced user to single user:

Make sure that you have activated the “super user” functions according to the
instructions above. Afterwards change to the menu and choose „Options“.

In the submenu please select „o Userlevel“ (2 times - Options – o Userlevel)

Confirm by pressing the button. Now the single user is activated.

Changing from single user to advanced user:

Keep both the buttons and pressed directly after switching on the device. Your
MCT-HS-PRO automatically starts the main menu. Activate the the “super user”
functions according to the instructions above.

Navigate to “Options – o Userlevel” and confirm by pressing the button.

10.0 MEASURING VALUE OUT OF RANGE

If the measure value is blinking, the valid measuring range
is exceeded (limits see sectien 1.0). In this case the
accuracy will be decreasing.