Checkline MCT-HS - Manual (Page 3)

 Electromatic Equipment Co., Inc.
-14-
NOTES
 Electromatic Equipment Co., Inc.
-3-
3.0 MEASURING PROCEDURE
1. For a correct measurement please ensure that the
device has the same temperature than the material
you want to measure (+/-3°C). For that reason, let
your MCT-HS-PRO adjust to the surrounding
temperature of the material for at least half an hour
before measuring (protect from direct sunlight!).
2.) Switch on the device: Press the
key for 3
seconds.
3.) To change the calibration curve, please press the
or key.
4.) Plug the probe into the material. The display shows
the water content immediately.
5.) Pay attention to the direction of plugging in! (pay
attention to the following page!)!
6.) To save the results in the save menu press the
( button). The storage was successful when the
number in front of the
symbol increased. To
reach the store menu please press ( ) until the
appears.
ATTENTION! Risk of injury!