Checkline BM - Manual (Page 3)

 Electromatic Equipment Co., Inc
-14-
NOTES
 Electromatic Equipment Co., Inc
-3-
9. Smooth the material by hand.
10. Select the right calibration curve for your material
under test using the buttons or . The weight of
the material in the measuring chamber must be the
same as the calibration curve.
The display shows the water content.
11. If the measure value is blinking, the valid measuring
range is exceeded (limits see list on page 5). In this
case the accuracy will be decreasing. If you are
measuring wood chips, select the next higher weight
class and refill wood chips to reach the higher filling
weight.
12. To save the results in the save menu press the (
button). The storage was successful when the number in
front of the symbol
increased. To reach the store
menu please press until the appears.
13. To name the saved results press the
button.
14. Empty the BM2 and ensure that no material rests are
accumulated in the measuring chamber.
Measuring process of wooden pellets:
Measure wooden pellets with the calibration curve “5.0k Pellets”. For this
measurement the bucket not has to be full of pellets, you must fill in 5,00 kilograms
of wooden pellets every time.
Measuring process of dry wood-shavings:
Is the 13 litre bucket not big enough for 1,00 kilogram of shavings, the measuring
device has to be filled separately (e.g. 2 x 0,50kg). During the filling process the
measuring material has to be slightly and constantly compressed in the measuring
chamber in order to provide enough place for 1,00kg of shavings. After finishing the
filling process, all of the measuring material has to be 5cm below the back case
edge.
List of calibration curves
Pressing the or key in the measuring for at least 3
seconds and a list with all available sorts will appear. Select
your sort by pressing
or and confirm it with the key.
The measurement will continue automatically.