Checkline 3000EZ Series - Manual (Page 6)

6
Ferr — indicates Ferrous Mode.
Non-Ferr — indicates Non-Ferrous Mode.
AUTO FN — indicates Auto-Select Mode.
3.4 Total Reset to Factory Defaults
1. Switch the gauge off.
2 Press and hold the ZERO key. At the same time, turn on
the power using the ON/OFF switch
3. An acoustic signal will sound, all statistical values will
deleted and the factory settings µm, calibration, and
AUTO FN (DCFN-3000EZ only) will be activated.
3.5 Battery Replacement
3000EZ gauges use 2x AAA alkaline batteries. When battery
power becomes low, the BATTERY INDICATOR will begin
to flash. The gauge will continue to operate, but the batteries
should be replaced as soon as possible. When battery power is
depleted, the Battery Indicator will remain
on continuously,
indicating that less
than 60 seconds of
power remains before
the gauge will shut off.
11
6.1 Clearing the statistical values:
To clear the statistical values, momentarily press and release
the ON/OFF switch. A value of zero will be shown in the
number or measurements field “n” confirming that the stored
statistical values have been cleared.
6
Ferr — indicates Ferrous Mode.
Non-Ferr — indicates Non-Ferrous Mode.
AUTO FN — indicates Auto-Select Mode.
3.4 Total Reset to Factory Defaults
1. Switch the gauge off.
2 Press and hold the ZERO key. At the same time, turn on
the power using the ON/OFF switch
3. An acoustic signal will sound, all statistical values will
deleted and the factory settings µm, calibration, and
AUTO FN (DCFN-3000EZ only) will be activated.
3.5 Battery Replacement
3000EZ gauges use 2x AAA alkaline batteries. When battery
power becomes low, the BATTERY INDICATOR will begin
to flash. The gauge will continue to operate, but the batteries
should be replaced as soon as possible. When battery power is
depleted, the Battery Indicator will remain
on continuously,
indicating that less
than 60 seconds of
power remains before
the gauge will shut off.
11
6.1 Clearing the statistical values:
To clear the statistical values, momentarily press and release
the ON/OFF switch. A value of zero will be shown in the
number or measurements field “n” confirming that the stored
statistical values have been cleared.
Battery Indicator