Checkline ESMH - Manual (Page 4)

Model ESMH Motorized Test Stand
3
SAFETY TIPS
■ Wear eye and face protection when testing. Although the ESMH
has relatively slow moving mechanisms, be aware of the dangers
posed by potential energy that can accumulate in a sample during
testing.
■
Keep away from the moving parts of the test stand.
■ Never operate the test stand if there is any visible damage to the
power cord or the control unit. The ESMH is powered by 110/220V
AC current that is present in both the power cord and the control
unit. Any contact with this high voltage can cause serious injury or
even death.
■
Ensure that the control unit is kept away from water or any other
liquids at all times.
■ Make sure the electrical outlet powering the test stand has local
earth ground (3-hole outlet).
■ Opening up the cover of the control unit is not recommended, as
there are no user-serviceable parts inside. If you wish to open it, be
sure to disconnect power before doing so. If any repairs are
needed, contact Mark-10 or your distributor.
SETUP
Mounting to a workbench
Place the ESMH on a clean, flat and level work area that meets the
criteria outlined in the work area safety instructions. For accurate read-
ings, the area should be free of vibrations.
If desired, the test stand can be mounted to the work area with four
5/16 screws.
User’s Guide
8
DIMENSIONS IN [MM]
2.63 [66.7]
23.25 [590.6]
20.00 [507.9]
5.25 [133.4]
2.00 [50.7]
7.25 [184.1]
2.23 [56.6]
2.23 [56.6] 2.65 [67.3]
0.50 [12.7]
1.30 [33.0]
0.50 [12.7]
#10-32 UNF
X15
0.32 [8.1]
13.10 [330.0]
MAX (BG/EG)
13.50 [343.0]
MAX (MG)
OPTIONAL TRAVEL DISPLAY