Checkline Series-2 - Manual (Page 5)

Series 2 Digital Force Gauges User’s Guide
4
Battery life is approximately 24 hours with the backlight on, or 92 hours with the backlight off. To change
the battery, loosen the two captive screws on the back side of the housing and separate the two housing
halves. A foam strip separates the battery from the PCB, as shown in the illustration below:
Ensure that the foam is positioned above the battery when reassembling the housing. Exercise care when
reassembling the two halves of the housing, ensuring that internal wires do not interfere.
3 MECHANICAL SETUP
3.1 Loading shaft orientation
In order to accommodate a variety of testing requirements, the orientation of the loading shaft may be
oriented in either of the two positions shown below. In order to change the loading shaft orientation,
loosen the two captive screws on the back side of the housing, separate the two housing halves, rotate
one half 180 degrees, and reassemble. Exercise care when reassembling the two halves of the housing,
ensuring that internal wires do not interfere.
Load cell shaft up Load cell shaft down