Checkline Series-2 User Manual

Page 13

Series 2 Digital Force Gauges

User’s Guide

To save the calibration information, select “SAVE & EXIT”. To exit without saving the data select
“EXIT W/O SAVING”.

14. Any errors are reported by the following screens:

Displayed at the start of calibration if a disallowed unit is selected.

Ensure that the load is not swinging, oscillating, or vibrating in any manner. Then try again.

The calibration weight does not match the set value.

The entered calibration point is too close to the previous point.

9 OTHER SETTINGS

9.1 Automatic Shutoff
The gauge may be configured to automatically power off following a period of inactivity while on battery
power. Inactivity is defined as the absence of any key presses or load changes of 100 counts or less. To
access these settings, select Automatic Shutoff from the menu. The display will appear as follows:

CALIBRATION

TENSION

LOAD TOO CLOSE

TO PREVIOUS

PLEASE TRY AGAIN

LOAD NOT STABLE

PLEASE TRY AGAIN

CALIBRATION

Units must be gF.

PLEASE TRY AGAIN

PRESS ENTER

CALIBRATION

COMPRESSION

LOAD TOO LOW

PLEASE TRY AGAIN