Brookfield DV2T Extra Viscometer - Manual (Page 14)

Brookfield Engineering Labs., Inc. Page 14 Manual No. M13-167-B0614
Figure II-2
The operator must ensure that the viscometer is level (see Section I.4) and remove any
attached spindle or coupling. When the Next button is pressed, the viscometer will operate
for approximately 13 seconds. After the AutoZero is complete and the operator presses
the Next button, the viscometer will transition to the Configure Viscosity Test screen. If
the AutoZero was performed from the Settings Menu, then the viscometer will return to
the Settings Menu.
TIP: Do not touch the viscometer during the AutoZero process to ensure the best zero
value.
II.3 Status Bar
The DV2T Viscometer will display a status bar at the top of the screen at all times.
This status bar will indicate: time of day, date, and connection status for a variety of
connection devices. The status icons are defined as:
USB Icon 1,2,3: The DV2T Viscometer can store data and tests to USB
storage device (USB B) such as a USB Flash Drive.
There are three USB ports. These ports are represented
as 1, 2 and 3 based on the order of connection.
Printer Icon: The DV2T Viscometer can communicate to a label printer
for printing test results (see Section II.8).
Computer Icon: The DV2T Viscometer can communicate with a computer
through the USB A port. Communication is supported
with Brookfield RheocalcT software.