360 Systems Instant Replay DR-550 - Manual (Page 29)

Instant Replay Owner’s Manual page 23
Restore From Backup
Restores the internal hard disk contents through the AES/EBU (XLR-3) input connector from
a DAT tape previously created via BACKUP BANK or BACKUP DRIVE.
File Receiver
Selects whether file reception is ON or OFF. When ON, an idle machine receives all file
transfers specifying a destination name that matches the configured receiver name. When
OFF, the machine does not receive file transfers.
Echo During Receive
Selects whether received data is passed through to the digital output. The ON selection is
useful when machines are daisy-chained for file transfer. Note that any machine in a daisy-
chain that is playing or recording can not echo file transfer data to subsequent machines. The
OFF selection prevents file transfer data from being echoed through the digital output.
Receiver Input
Selects either the RCA or the XLR-3 digital input connector for receiving files.
Receiver Name
This field specifies an optional name for addressing the receiver during file transfer. A blank
name causes a machine to receive all file transfers from any source machine (provided the
destination drive and directory are correct).
The name specified as the destination machine may end with a single asterisk character (Hot-
Key 40) to indicate that all receivers partially matching the name should receive the transfer.
For example:
EDITBAY* will transfer to EDITBAY 1, EDITBAY 2, EDITBAY 3, etc.
Leading and trailing blanks in names are not significant and are removed whenever a name is
saved.
When sending to a specific location instead of sending to a mail box, the destination drive
defaults to '1', the destination directory defaults to '0' and the destination index defaults to the
index of the currently selected cut in the source machine. Applicable portions of the
destination disk location may be edited by the user.
Transfers To Accept
This menu determines whether transfers can be to locations outside of the mail box. The
MAIL BOX ONLY choice causes the receiver to accept transfers with a destination location
of MAIL BOX and to reject transfers to specific locations. The ALL choice causes the
receiver to accept MAIL BOX transfers as well as transfers to specific locations.
File Transfer Setup (First Time Configuration)
1. Select the file transfer menu.