Panasonic CF-VDD272 - Manual (Page 9)

5 Press [ Alt ) +(H) ■ then to save the file. Then press
C
Alt ) + CFl. then cs to
exit the Edit program.
Q Follow the same steps to edit the "AUTOEXEC.BAT" file,
edit autoexec.bat ( Enter ]
7
Move the cursor to the line containing "MSCDEX.EXE" and delete the characters "rem"
at the beginning of the line. (Deleting "rem" causes the item to become valid.)
LOADHIGH C:\WlNDOWS\COMMAND\MSCDEX.EXE /D:MSCD000 /L:L
(If this line is missing, add it.)
8
Press ( Alt) + m , then C S ) to save the file. Then press ( Alt) + CF). then ( X ) to
exit the Edit program.
8
Restart the computer.
Power-saving mode
If the DVD-ROM Drive Pack has not been accessed within 120 seconds, the drive motor
will automatically shut down to reduce the power consumption. When the DVD-ROM
Drive Pack is accessed once again, the power of the drive motor is turned on. However,
approximately 30 seconds are required until data is actually read from the disc.
/•C note >
• [3'^ Floppy (A:)] displayed in [My Computer] can be selected, only when you use a
floppy disk drive as an external device (ç^ page 6).
•References to "CD-ROM" in the Setup Utility will not change depending on the
computer when the DVD-ROM Drive Pack is installed.
• If the vibration of the DVD-ROM drive is excessive, set the CD-ROM/DVD-ROM
Drive Speed to [12x](or displayed [Low]) in Setup Utility. ( The display of the item
may remain unchanged depending on the computer when the DVD-ROM Drive Pack
is installed. )