Panasonic TX-47WG25 - Manual (Page 33)

General Operation
Colour System Selection (Different countries use differing systems)
1,3 2 (Remote Control) ^
о о 6 о о
DISPLAY TV/AV PRE, - ^ + V Л
OR
и
[А]
т
СШ]
1,2
(TV set)
If a clear picture with current colours cannot be obtained when a Broadcast or AV signal is received.
1
pre ;
№1NME№J
Push the “PRE.” (PRESET)
Button 6 times.
Push the “MAIN MENU” and
“Position” Buttons, until the
Preset Menu to “COLOUR
SYS”.
1 PRESET
CH 1
CH SELECT DIRECT
SYS SELECT CHINA
AUTO TUNE
MANUAL TUNE
SOUND SYS 5.5MHz
I COLOUR SYS I AUTO
FINE TUNE
SKIP
OFF
Colour System Condition.
2 О
Mlt4MBU
□ C a ]
E]
Cvj
Push the Volume Up “+” or
Down Button repeatedly
until the optimum image is
produced.
Push the Position Left “<” or
Right “>” Button repeatedly
until the optimum image is
produced.
1 PRESET
CH 1
CH SELECT DIRECT
SYS SELECT CHINA
AUTO TUNE
MANUALTUNE
SOUND SYS 5, SMHz
\ COLOUR SYS i;PAL?
FINE TUNE
SKIP
OFF
The colour system will change
as shown.
AUTO ^—> PAL<—> SECAM
I
I
NTSC3.58 <------ > NTSC4.43
Note:
PAL, SECAM and NTSC 3.58
are different colour signal
broadcast transmission systems
applicable to differing countries.
NTSC 4.43 is a trick playback
mode used in special VCR’s to
playback NTSC recorded video
tapes through PAL television
equipment.
Push the “PRE.” (PRESET)
Button 3 times. (In AV Mode it
is only necessary to push the
“PRE.” (PRESET) button once.)
MAIN MENU Push the “MAIN MENU" Button
twice.
This returns the set to the
normal viewing condition.
The selected Colour System is
automatically memorised.
33