Note, Helpful hint, Tuning procedure – Panasonic TX-47WG25 User Manual

Page 25

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Tuning Procedure

5 O

WIN MENU

□ C

]

if the sound is not clear or no
sound is produced on a Pro
gramme Number Position, push

the Volume Up “+” or Down

Button.

if the sound is not clear or no
sound is produced on a

Programme Number Position,

push the Position Left “<” or

Right “>” Button.

2 PRESET

CH 2

CH SELECT DIRECT
SYS SELECT CHINA
AUTO TUNE
MANUAL

tune

! SOUND SYSl?S. SMHz'i

COLOUR SYS XUtd'"

RNETUNE
SKIP

OFF

You may improve the Sound
quality.

The sound indicator will

change as follows.

->4.5MHz05.5MHz^

Ue.sMHzoe.oMHz^

Note:

When sound volume is too
small to confirm, turn it up by

using the sound volume button
on the remote control.

Push the “PRE.” (PRESET)
Button 4 times.

Push the “MAIN MENU”
Button twice.

This returns the set to the

normal viewing condition.

Helpful Hint

(1) If a clear picture cannot be obtained even when a Broadcast or AV signal is received, refer to the “Colour System

Selection” operation on page 33.

(2) After the Manual Tune is finished, push the Programme Number “Up” Button to confirm the tuning condition for

each Programme Number. If Programme Numbers are unused, it is possible to skip such Programme Numbers.

Please refer to the Programme Number skip operation on page 28.

(3) When using VCR without video and audio input/output terminals for, it is convenient to connect the aerial cable

as indicated in the instruction manual of VCR and to set the designated channel to programme No. “0”. In that
case, perform manual search after setting the colour system and sound system in advance. Further, in multi
system VCR, it is much convenient to set the designated channel to several programme Numbers.