Panasonic CF-VDL01 - Manual (Page 9)

Touchscreen
The LCD Monitor is equipped with a touchscreen function allowing you to perform the same operations as the touch pad or mouse
by touching the surface of the display with your finger. (The operation settings can be changed in [Start] - [Programs] - [Updd] -
[Settings].)
Moving the cursor
Cursor
Double-clicking
Clicking
Dragging
Touch and hold the object (i. e.
file or icon), move your finger
on the surface (dragging the
object to the desired location),
then release your finger.
r
The touchscreen function can not be used in the MS-DOS mode and when using the full
screen in [MS-DOS prompt].
When the operation of panning (only LCD) is performed while the screen resolution is
set to [1024 X 768 dots] or more, the touchscreen function will not work properly.
If a change is made to the screen resolution, or the cursor can not be pointed correctly
with your finger, be sure to perform calibration in the [Start]-[PTograms]-[Updd]-[Cali­
brate] menu.
rHandling-the-Touchscreen-|
Do not place any object on the surface or press down forcefully with sharp-pointed objects
(e.g., nails), hard objects that can leave marks (e.g., pencils and ball point pens).
Do not apply pressure within 5 mm of the perimeter of the display panel. The cursor may
move to the edge of the display.
Do not operate the computer when such things as dust are on the screen, or allow contact
with substances that could dirty the touchscreen, such as oil. The cursor may not work
properly in such cases.
When the touchscreen becomes dirty:
Use a dry soft cloth such as a gauze to clean the dirty areas.
Do not use benzene, thinner, or disinfectant- type alcohol.