Panasonic CF-VDL01 - Manual (Page 10)

Touchscreen
rConfiguringtheTouchscreenn
When needed, the touchscreen can be configured using the following steps.
y Select from the taskbar or select [Settings] from [Start] - [Programs] - [Updd]
The following screen will appear.
—Calibration
Define the calibration setup.
Use when the cursor can not be pointed correctly with your
finger. (Needed if the alignment of the touchscreen with the
visual image change or adjust the display resolution).
Before you run the calibration, you need to set the device at
[Calibration settings for] as followings.
[Device I ] is for the computer
[Device2] is for the LCD Monitor
________ Status
Display the status of the controller.
Windows
Set the “double-click” set­
tings.
Devices
Configure the device controller.
Hardware
■Ei
Set the hardware resources.
Match this setting with the setting
for [Touchscreen] and [Serial Port
B] in the Setup Utility.
TljiTiinmjitiw wi «t nsul
02 P m « 2
Settings-----------------
Set the general protocol
settings.
=1
At
ir -AJd- -j
fr fîw
Caned [[[ oto ;
.About
Display the version number.
Button Modes
Set the button modes.
- General
Set the general settings and functions.
Events
Set the events that can be generated by a
controller.
Advanced
Set the advanced settings.
X note >
For more information, refer to [Help].
2 Make necessary changes
Click [OK]
NOTE^
Adjustments can be made when double-click operations are assumed by the computer although single-click opera­
tions are intended, by clicking [Windows] from the display shown above and decreasing the value for [Time] in
[Double Click Settings].
It is also possible to change the double click speed for [Buttons] in [Start] - [Settings] - [Control Panel] - [Mouse]. It
is important to note that when the double click speed for [Mouse] is changed, the double click time for [Windows] is
also changed. However, the double click time for [Windows] and [Mouse] returns to its value before the change
when the computer is restarted.
Immediately run [Calibrate] when the number of points of calibration is changed.
1 0