Panasonic TU-IRD10 - Manual (Page 3)

IM PORTAN T SAFEGU ARD S
In addition to the careful attention devoted to quality standards in the manufacture of your product, safety Is a
major factor in the design of every product. However, safety Is your responsibility too.
This sheet lists important information that will help to assure your enjoyment and proper use of the product and
accessory equipment. Please read them carefully before operating and using your product.
Installation
1 Read and Follow Instructions— All
the safety and operating instructions
should be read before the product is
operated.
Follow all operating
instructions.
2 Retain Instructions— The safety
and operating instructions should be retained for
future reference.
3 Heed Warnings— Comply with all warnings on the
product and in the operating instructions.
4 Polarization/Grounding— This product is equipped
with either a polarized, non-polarized, or a grounding
type
power cord plug. If equipped with the non­
polarized type (two blades of identical size), the
following does not apply.
• A polarized power plug (two blades, one
wider than the other) will fit into a power
receptacle only one way. This is a safety
feature. Do not defeat it. If you are unable to
insert the plug fully, try reversing it, or have
an electrician change the receptacle. If you
need an extension cord, use only a polarized extension
cord.
•A grounding type power plug (two blades and
a round pin) will fit only into a grounding type
receptacle with matching openings. This is
safety feature. Do not defeat it. You may need
an-electrician
to install a grounding type
receptacle. If you need an extension cord, use
only a grounding type extension cord.
5 Power Sources— This product should be operated
only from the type of power source indicated on the
product’s marking label. If you are not sure of the type
of power supply to your home, consult your dealer or
local power company. For products intended to
operate from battery power, or other sources, refer
to the operating instructions.
6 Overloading —Do not overload wall outlets or
extension cords as this can result
in a risk of fire or electric shock.
Overloaded AC outlets, extension
cords, frayed power cords,
damaged or cracked wire
insulation, and broken plugs are
dangerous. They may result in a
shock
or fire hazard. Periodically
examine the cord, and if its
appearance indicates damage or deteriorated
insulation, have it replaced by your service technician.
m
7
Powei^Cord Protection —Power-supply cords
should be routed so that they are not likely to be
walked on or pinched by items placed upon or
against them^ Pay particular attention to cords
where they are attached to plugs, converiience
receptacles and at the point where they exit from
the product.
8 Ventilation— Slots and openings in the enclosure
are provided for ventilation to ensure reliable
operation of the product and to protect it from
overheating. These openings must not be blocked
or
covered. These openings should never be
blocked by placing the product on a bed, sofa,
rug, or other similar surface; This product should
never be placed near or over a radiator or heat
register, or another heat source (including
amplifiers). This product should not be placed in
a
built-in installation such as a bookcase or
equipment rack unless proper ventilation is
provided or the product manufacturer's
instructions have been followed.
9 Attachments— Do not use attachments unless
recommended by the product manufacturer as
they may cause hazards.
10 Water and Moisture— Do not use this product
near water—for example, near a bath tub, wash
bowl,
kitchen sink or laundry tub, in a wet
basement, or near a swimming pool and the like.
11 Accessories —Do not place this product on an
unstable surface or support. The product may fall,
causing serious injury to a child or adult as well
as serious damage to the product. Any mounting
‘ of the product should follow the manufacturer's
instructions and use only a mounting accessory
recommended by the manufacturer.
11A A product and cart combination should be
moved with care. Quick
stops, excessive force, and .
uneven surfaces may cause
the product and cart
combination to overturn.
II