Panasonic Cx-dp88u - Manual (Page 16)

I Installation Guide
Continued
□ Installation Location
Do not install this unit on the rear tray of a car where the internai temperature can rise to high ievels. Faiiure to
comply with these instructions may cause probiems. Aiso avoid instailing the unit in the foiiowing locations.
• In areas hit by direct suniight, hot air from the heater, or any other high-temperature location.
• In an area where you cannot firmly secure the unit, or in high-vibration areas.
• In areas with high humidity or high dirt and dust levels.
How to install this unit
Use a screwdriver to set the angle-adjusting screw to the position “V" or "H," depending on the mounting angle
selected. {When shipped from the factory, the angle-adjusting screw is set to the “H" position as default.)
• When setting vertically: Set to the "V" position.
• When setting horizontally: Set to the “H" position.
Cautions;
• Set the angle-adjusting screw to the same angle as
selected.
• Set the hole to the same positions for both left and
right.
This unit can be set in the five direc­
tions: horizontal, vertical, and the posi­
tions A (22.5'*), B (45“), and C (67.5“).
Mount the unit by referring to the fig­
ures below.
-V
Angle-adjusting screw
How to install the unit and select the mounting angle
Installation Angle Selecting a mounting angle
Typical horizontal installation
(Normal) (Up-side down)
О X
Limit to less than 10 degrees.
и
I
.... .....
Limit to less than 10 degrees.
Ф-
Set the screw to the same
positions tor both left and right.
Typical vertical installation
(Normal) (Up-side down)
О X
Do not tilt in this Limit to
direction. Limit less than
to less than 10 10 degrees,
degrees.
I •
©
e
• I
\ I
V
-©
Set the screw to the same
positions for both left and right.
16
CX-DP88U