Panasonic PV-HS1000 - Manual (Page 21)

Input Options
Cable
If you have cable television but no cable box, select your cable service provider. If your cable service is not listed on
the screen, send mail to [email protected] or call 1-888-843-9788.
Cable box
If you have a cable box connected to the Hard Disk Recorder, select your cable service provider. You will also need
to connect and position the IR blaster that came with the Hard Disk Recorder. This is required so the Hard Disk
Recorder can change the channels on your cable box. Once the IR blaster is positioned, you will need to enter the
proper setup code for your cable box. See "Connecting and Setting Up the IR Blaster'’ on page 17.
DIRECTV
If you are not using a serial connector, you will need to connect and position the IR blaster that came with the Hard
Disk Recorder. This is required so the Hard Disk Recorder can change the channels on your DIRECTV receiver. Once
the IR Blaster is positioned, you will need to enter the proper setup code for your DIRECTV receiver. If you will be using
the supplied IR blaster to control your receiver, see "Connecting and Setting Up the IR Blaster" on page 17.
DISH Network™
If you have a DISH Network receiver connected to the Hard Disk Recorder, you will need to connect and position
the IR blaster that came with the Hard Disk Recorder. This is required so the Hard Disk Recorder can change the
channels on your DISH Network receiver. Once the IR blaster is positioned, you will need to enter the proper setup
code for your DISH Network receiver. See “Connecting and Setting Up the IR blaster" on page 17.
Completing the IR Blaster Setup
After you have connected the IR blaster, you need to provide the Hard Disk
Recorder with the setup code for your cable box or satellite receiver. This is
the final step in ensuring the Hard Disk Recorder and your cable box or
satellite receiver work together. Setup codes can be found in “Code
Numbers For Your Components” on pages 47 and 48.
1
2
Make sure the cable box or satellite receiver
power is on.
Find the setup code for your cable box or
satellite receiver
in “Code Numbers For Your
Components” on pages 47 and 48.
• If more than one code is listed, use the first one.
Press A/V to select your cable providers, then
press PLAY twice to move to the next screen.
Press Number buttons
to enter the code for
your device.
\ .VIFi Blaster
Press DISPLAY to
test if the code is
correct for your device.
• The cable box or
satellite receiver will turn
off if the code is correct.
• If the code does not
work, try each additional
code for your device.
U«« ch« Chsrmcl butteos U j cyd* thnwgh th« codi
iiun*
minibaf butierts «n tha ranwHa coAtrei. Tha coda numtMf
For ydOr davica can ba found in tha Jsar duid»^
Press DISPUkV test tha code iHimter. lha DISH
Fiatwork racaivar tnfl turn OFF whan tha opd* numtar is
oorracL
Pran STOP to dair tha coda numiiar,
JR BlcistCf Code: 0 T 7 S
Prass PEW to gn bodt to fft Blaster
PlAVta usa rafMCe control cade rtumber 0773^
Press PLAY to use the code you select and
move to the next screen.