Panasonic OMNIVISION PV-8401 - Manual (Page 18)

Timer Recording
^Important: If the remote control POWER, ACTION, PROG, CHA/T , INDEX, or ADD/DLT button does
not work when pressed, press the VCR button on the remote and try the button again.
You can set up the VCR to record a one
time, daily, or weekly program white you are
away or otherwise occupied. Up to 8
programs can be stored in memory.
I^^Check list before you begin.
Q All connections are made.
(See pages 6-9.)
D
TV and VCR are plugged in and turned on.
n VCR/TV selector is set to “VCR.”
ID Clock is set to correct time.
□ Record tab in place. (See page 5.)
—--------------- n\
Multi Function Display
1
5
6
Important notes when using a
DSS receiver
• When recording programs via a DSS
receiver, the DSS receiver must be left on.
• When recording programs via an antenna or
cable, the DSS receiver must be turned off.
1
Press PROG* to display the
“SET PROGRAM” screen.
Press AT to select “TIMER
PROGRAM,” and then press ►
to display the program screen.
• If a program is already in memory, press AW
and ► to select an unused program number.
--- SÊT PROGRAM --
VCR PROGRAM
TIMER PROGRAM
SEUeCTrA ▼ KEY
SET ;► KEY
END :PROG KEY
Press AT and ^ to select and
set one of the following;
• 1-31 =Onetime recording
• DAILY =Same time MON-FRI
• WEEKLY (SUN-SAT) =Same time once a week
'31— 1 — 2 —
SELECT START DATE
SELECT : A ▼ KEY
SET ;► KEY
El® :PflOG KEY
Example
Today’s Date
9-
7 SELECTA/T Selection Order DAILY
L weekly weekly weekly J
(SAT) ....... (MON) (SUN)
4
Press AT and
to select and set each
of the remaining
items at right.
Remaining Items to be set;
• START time
• STOP time
• CH(annel) number, or LINE for
outside source recording
• Speed (SP, LP. SLP)
To Make Corrections
Repeatedly press ► to move the cursor to the right, or M to
move to the left to the incorrect entry and make the correction.
5
Press PROG to end the program.
• This screen appears for confirmation.
To Enter More Pfograms
Press AT and ► to select and set a blank
program number, and then repeat steps 3 and 4.
Press PROG to exit this mode.
Press POWER off to set the timer.
• When recording programs via a cable
box, make sure the cable box is left
ON and tuned to the desired channel.
P DT START STOP CH SPD
2
-----
3 --------
4
----
CANCEL
SELECT
ENTER
END
ADD/D
1-8: A
► KEY
PROG
-T KEY
▼ KEY
ŒY
-HE5@S-
Multi Function Display
• A cassette with no record tab is ejected and "TIMER" flashes when the power is turned off to set the timer.
• If the start times of two programs overlap, the tower numbered program will have priority.
• If the start time for a timer recording comes up during a normal recording or One Touch Recording (page 17),
the timer recording will not be performed.
• If there is a power interruption of more than one minute, tiie recording will not be performed or continue.
18