Panasonic PHONE KX-TC1696B - Manual (Page 36)

Voice Mail Service
Setting the Voice Mail Tone
If your voice mail service sends a voice mail tone after a new message has
finished recording, set to “On”. The VOICE MAIL indicator will flash if a
message was recorded in your mailbox. You will hear a series of voice mail
tones then a dial tone after pressing iTALKl.
(Contact your service provider about your service.)
Set to “Off” when:
— you do not subscribe to a voice mail service,
— your voice mail service does not send a voice mail tone, or
— the unit is connected to a PBX.
Your phone comes from the factory set to “On”.
The TALK indicator light must be off before programming.
1
2
3
A To select “Off’, press
SEARCH 0.
^ OR
To select “On”, press SEARCH ©.
• A long beep sounds and the setting is
saved.
• The handset will return to the stand-by
mode.
Press 1 PROGRAM 1. Save AUTO# 7
• The TALK indicator flashes.
v=Next A=Yes
Press SEARCH © (Next key) repeatedly Voicemail tone?
until “Voicemail tone?” is displayed.
v=Next A=Yes
Press SEARCH 0(Yes key).
Voicemail tone
v=On
A
= Of f
Voicemail tone
Off
Voicemail tone
On
• To cancel during programming, press I
EXIT
I or I
PROGRAM!,
then start
from step 1.
• If 3 beeps sound and the display shows “Save error”, move closer to
the base unit and try again. If “Save error” is still displayed, place the
handset on the base unit. Restart from step 1.
If a power failure occurs, the setting will return to the factory preset (On).
Reprogram if necessary.
36