Panasonic TU-DST50 - Manual (Page 49)

S pecial F eatures
Special Features
SETUP
Antenna/Cable Mode
Select either Antenna or Cable mode, depending on the type of incoming signal you
are using. Cable must be 8VSB format.
Procedure
□
In SET UP Menu, select INPUT to choose either ANTENNA or Cable.
□ Press the ^ arrow, then the A and V arrows to select ANTENNA, Cable STD, Cable HRC
or Cable IRC.
• ANTENNA - VHF/UHF
• Cable STD - Standard Cable TV Signals
• Cable HRC - Harmonic Related Carrier
• Cable IRC - Incremental Related Carrier
Note: Contact your local cable provider if you are not sure which setting to use.
□
Press the ACTION button to make your selection.
□ Press the ^ arrow to exit back to Roller Guide.
Note: Whenever the antenna or cable mode is changed, Timer 1 and Timer 2 will revert back
to default settings.
Programming Available Channels
You must perform the automatic channel programming before manually adding and
deleting channels because of the digital tuning system used by the STB. This method
will ensure that every available channel will be captured and stored into memory.
Automatic Channel Programming
The STB will scan for all available channels and store them in memory. The scan will
normally take several minutes to complete.
Procedure
□ In SET UP Menu, select PROGRAM to choose AUTO to automatically scan and store all
channels with a signal.
• Press the ACTION button to cancel or exit back to SET UP Menu.
Note: As more digital channels become available in your area, the AUTO
feature must be selected to store the new digital channels into memory.