Procedure – Panasonic TU-DST50 User Manual
Page 27
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
G
etting
S
tarted
Step 3f. Digital 8VSB Cable/Analog Cable with Conventional TV
Follow this diagram if you have a conventional TV, cable service providing 8VSB
digital cable and you want to receive digital cable channels through the STB and
analog cable channels through the cable box (or through the TV if you have no cable
box).
Note:
The STB is able to receive DTV signals from your local cable provider only if they are
transmitted in the 8VSB modulation format approved by the FCC for DTV
transmission. Also, your cable provider may elect to transmit in the 8VSB format for
only a limited period of time. Please contact your cable provider to determine if
8VSB modulation is available.
Analog Signal optional Cable Box
NOTE: ANTENNA, SPLITTER, CABLE BOX, RF
CABLES, S-VIDEO, VIDEO AND AUDIO
CABLES NOT INCLUDED
8VSB Signal
DIGITAL 8VSB CABLE/ANALOG CABLE RECEPTION WITH
CONVENTIONAL TV SETUP
Procedure
•
Connect the cable wire from the wall jack to the splitter using a standard RF cable with
coaxial connectors.
•
Connect one splitter output to the STB ANT (antenna) IN jack using a RF cable.
•
If using a cable box, connect the other splitter output to the cable box ANT (antenna) IN
jack using a RF cable. Connect the cable box ANT (antenna) OUT jack to the TV ANT
(antenna) IN jack using a RF cable.
•
If not using a cable box, connect the other splitter output to the TV ANT (antenna) IN jack
using a RF cable (not shown).
•
Follow directions in Getting Started section to connect the STB to a conventional TV.