Manual clock set, Reset all unit menx>ry functions, Note to cable system installer – Panasonic PV C2032W User Manual
Page 9
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Manual Clock Set
!f AUTO CLOCK SET was incomplete, manually
set the clock as follows.
1
Press ACTION on the Remote to
display SET CLOCK Menu screen.
SET CLOCK
SEL£CT :A ▼
SET
END : ACTION
Press
A T
to select the month
and press ► to set. In the same
manner, select and set the date,
year, time, and DST. (Daylight
Saving Time)
SET CLOCK
2/6/2002 WED 12«
SET :
START : ACT I ON
Press ACTION twice to start
CLOCK and exit.
Reset all unit Menx>ry Functions
When moving unit to a new location, or if a
mistake was made in the Initial Setup section.
• Make sure a tape is not inserted in the unit.
Press and hold both PLAY and
FF on the unit for more than 5
seconds.
• The power will shut off. ___
• Please ignore “NO CASSETTE”
warning.
Do “Initial Setup” on page 8.
SELECT/SET
A :CH UP
'f :CH DOWN
► :VOL UP
◄ :VOL DOWN
Note to CABLE System Installer
This reminder is provided to call the
CABLE (Cable TV) System Installers
attention to Article 820-40 of the NEC
that provides guidelines for proper
grounding and, in particular, specifies
that the cable ground shall be
connected to the grounding system of
the building, as close to the point of
cable entry as practical.