Connections/ initial setup (ready to play), Plug the unit power cord into an ac wali outlet, Connections / initiai setup (ready to play) ,9 – Panasonic PV C2032W User Manual
Page 8: Connections/ initial setup, Initial setup (ready to play)
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Connections/ Initial Setup
(Ready to Play)
Please make all cable or antenna connections before powering on.
Connecting
For ANT./Cable
Connect the cable from Antenna/
Cable to the VHF/UHF terminal
on the unit.
For DSS/Cable Box
Connect the OUT jack on your
cable box to the VHF/UHF
terminal on the unit with a RF
cable.
WARNING:
Overtightening "Nut type" RF coaxial cables
may damage jacks. Finger tighten only.
Initial Setup (Ready to Play)
1
2
Plug the unit power cord into an
AC wali outlet.
Press Power* on the remote or
unit. The unit comes on and auto
channei and ciock set starts.
Settings are made
automaticaliy. When setup is
done, this screen appears.
CH AUTO SET PROCEEDING
2/6/2002 ei2:00PH
DST:ON
SETTING : CH 10
AUTO CLOCK SET
COMPLETED
If you use a cable box, turn it on and set it to the
Public Broadcasting Service (PBS) channel in
your time zone. If you use a DSS reciever, it
must be turned off.
If AUTO CLOCK SET IS
INCOMPLETE screen
appears, set the clock using
MANUAL CLOCK SET
procedure as below.
AUTO CLOCK SET
PROCEEDING
CANCEL : PRESS STOP KEV
SET CLOCK
2/6/2002 WED 12:OOPM
DST:ON
SET COMPLETED
SET :
ST Am
: ACT I ON
8
For assistance,
please call:
1-800-211-PANA(7262) or
send e^nail
to
: consumeiprodLJCts@panasonic;conn