Panasonic PV C2032W - Manual (Page 26)

Tape Operation
(continued)
Zero Search
To quickly return to a specific tape counter location.
1 Press DISPLAY during playback to
display the Counter.
Repeat Play
Set to see a recording over and over.
1 Press ACTION to display
MAIN MENU.
Press COUNTER Q MAIN MENU
0:00:00 RESET at the ^ 1 ^ 1 1^1
desired position to 1
reset to “0:00:00.”
wr
i
' 'ii' ' "i
SEUECT
^ ►
BEGIN END
SET
t ACTION
Continue playback, rewind, or
fast forward.
Press STOP.
1:23:‘45
ZD
BEGIN END
Press CM/ZERO in
stop mode to start
ZERO SEARCH.
T: Present position mark
V: Zero position mark
Unit goes into FF or REW mode and stops at
the last point the Counter was set to 0:00:00.
If a blank portion exists on the tape, and
depending on the position of the V mark, the
V mark display may be out of position.
1) Press
to select ‘VCR.”
2) Press
ACTION to
display SET
UP VCR
screen.
TIMER PROGRAMMING
SELECT:
SET
:
END
1) Press AT to
select
“REPEAT
PLAY.”
2) Press ► to
set REPEAT
PLAY “ON” or
“OFF.”
Press ACTION twice
to end setup.
• Playback repeats when tape end is reached or
unrecorded portion over 30 seconds is detected.
• During playback, you may also press PLAY/
REPEAT repeatedly on the unit to select
REPEAT‘'ON” or "OFF.”
Commercial Skip
By pressing the CM/ZERO button in Playback mode
you can skip over 1 to 3 minutes of recorded tape in
just a few seconds.
1
Press CM/ZERO repeatedly to
select skip time in Play mode.
• No indication appears.
----->
-1 min Skip
-2 min SIdp
"3 min Skip
26
For assistance;, please caD : 1'80O211'PANA(7262) or send emai: to : consumerproducts@panasonicxom