Connections, O'" o o, Power source – Panasonic WV-BP310 User Manual
Page 9
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
CONNECTIONS
Power Source
■ WV-BP310
1. Connect the AC Power Cord (5) to a electrical out
let of 120V AC 60 Hz.
m
WV-BP314
1. A power supply of 24V AC 60 Hz is required.
2. Connect the power cable to the 24V AC in
Terminal (15) on the rear panel of the camera.
Recommended wire gauge sizes for 24V AC line.
Copper wire
size (AWG)
#24
(0.22mm=)
#22
{0,33mm=)
#20
(0,52mm=)
#18
{0.83mnrV)
Length
of Cable
(Approx.)
(ft)
314
495
842
1403
(m)
95
150
255
425
Caution:
To prevent fire or shock hazard, the UL list
ed wire VW-1, style 1007 should be used for
the cable for AC 24V Input Terminal.
Video Cabie
1, It is recommended to use a video monitor whose
resolution is at least equal to the camera's.
2. Terminate the camera output with 75-ohm resistor
at the furthest end of its cable run.
•
It is recommended to use 75-ohm coaxial
cable.
•
Always set the last monitor’s termination
switch to 75 ohms, and set the termination
switches of intermediate monitors to HIGH (Hi-
Z) position.
Monitor
Monitor
(
VIDEO
--------1
VIDEO 'I
75nr~M
Hl-Z
75ft
■Z]Hi-z
O'" O
o
IN
OUT
IN
OUT
24 VAC, 60 Hz
(19.5V-28 V)
-7-