Panasonic WV-BP310 - Manual (Page 18)

(5) Both the connector cover and connector should
be positioned to interlock.
Note:
Cut off the rib on the connector, when the iris
control cable is too thick and the connector
cover and connector can not be interlocked.
3. Mounting the Lens
When you use the lens other than listed on pages 10,
11, 12, 13 and 14, lens mount should be C-mount or
special C-mount (CS-mount r-32UN) and lens weight
should be less than 0.99 lbs. (450g). If not, both the
lens and camera should be secured.
The protrusion of the rear of the lens should be as
shown below.
C-mount: Less than 7/16" (11,5 mm)
CS-mount: Less than 1/4' (7,2 mm)
Caution;
Always set the Flange-back adjusting ring to fully
clockwise (C-mount side) by loosing one screw on
the ring before mounting the lens, otherwise the
inner glass and CCD image sensor could be dam­
aged by the lens.
(1) Mount the lens by turning it clockwise onto the
lens mount of the camera.
(2) Connect the lens cable to the Auto Iris Lens
Connector on the camera when an auto iris lens is
used.
-16-