Panasonic DVD-CV52 - Manual (Page 18)

Specifications
PAL625/50, PAL525/6P, NTSC
+ 5 to +35 °C
5 to 90 % RH {no condensation)
Signal system:
Operating temperature range:
Operating humidity range:
Discs piayed [8 cm or 12 cm]:
{1 ) DVD-Video, DVD-R (DVD-Video compatible)
(2) CD-Audio (CD-DA)
(3) Video CD
(4) CD-R/CD-RW {CD-DA, Video CD formatted discs)
(5) MP3
•Maximum number of tracks and groups recognizable: 999 tracks
and 99 groups
•Compatible compression rate: between 32 kbps and 32Ct;kbps
Video output:
Output level: 1 Vp-p (75 Q)
Output terminal: i.
For the United Kingdom and Continental Europe
For Australia and N.Z.
S video output:
Y output level:
C output level:
Output terminal:
Pin jack {1 system)/AVi;
Pin jack (1 system) ^
1 Vp-p (75 O)
NTSC; 0.286 Vp-p (7a O)
PAL; 0,300 Vp-p (7£ÌO)
For the United Kingdom and Continental Europe
For Australia and N.Z.
Component video output;
Y output level:
P b output level:
P r output level:
Output terminal:
S terminal (1 system)/AV
S terminal (1 system)
For Australia and N.Z.
1 Vp-p (75
Q)
0.7 Vp-p (75 0)
0.7 Vp-p (75 0)
Pin jack (1 system)
(Y: green, P b : blue, PR:jred)
RGB video output; j
R output level:
G output level:
B output level:
Output terminal:
For the United Kingdom and Continental Europi
0.7 Vp-p (75 O)
0.7 Vp-p (75 O)
0,7 Vp-p (75 O)
AV (1 system)
Glossary
Bitstream
This is the digital form of multiple channel audio data (e.i
before it is decoded into its various channels.
., S.tiChannel)
Decoder
A decoder restores the coded audio signals on DVDs to normal. This is
called decoding.
Dolby Digital i
This is a method of coding digital signals developed by Dolby Laboratories.
Apart from stereo (2-channel) audio, these signals can also be 5.|(-channel
audio. A large amount of audio information can be recorded or]ione disc
using this method.
Dolby Pro Logic
A surround system where a 4-channel audio track is recorded as 2
channels and then is restored to 4 channels for play. The surroun:|l channel
is monaural and can reproduce up to 7 kHz.
DTS (Digital Theater Systems)
This surround system is used in many movie theaters around the world.
There is good separation between the channels, so realistic sound effects
are possible,
ii
Dynamic range
Dynamic range is the difference between the lowest level of soun
be heard above the noise of the equipment and the highest leve
before distortion occurs.
;lthat can
of sound
Audi
Out
Out
3 output;
put level:
put terminals:
Pin jack
Nujmber of terminals:
2ch:
Subwoofer output (0.1ch):
Audib performance:
(1) Frequency response:
• DVD (linear audio):
Digit It
Op
Pickti
NORSK
ip: Pickii
Spec
Mass
For the United Kingdom and Continental Europe
For Australia and N.Z.
2 Vrms (1 kHz, 0 dB)
Pin jack/AV
•CD audio:
S/N ratio:
•CD audio;
Dynamic range:
• DVD (linear audio):
• CD audio:
Total harmonic distortion:
•CD audio;
audio output;
ical digital output:
P: Wave length:
Laser power:
Bolgelengde:
Laser-styrke:
Pow( r supply:
Pow€ r consumption:
Dimensions;
Mass
1 system
1 system
4 Hz-22 kHz (48 kHz sampling)
4 Hz-44 kHz (96 kHz sampling)
4 Hz-20 kHz
115dB
102 dB
98 dB
0.0025 %
Cptical terminal
058 nm/790 nm
CLASS 2/CLASS 1
658 nm/790 nm
Ingen farlig straining sendee ut
KLASSE 2/KLASSE 1
AC 220-240 V, 50 Hz
14 W
430 (W)X406.5 (D)x75.8 (H) mm
4.5 kg
Power consumption in standby mode: approx. 3.8 W
fications are subject to change without notice,
and dimensions are approximate.
Frarr e still and field still
Framus are the still pictures that go together to make a moving picture.
There are about 30 frames shown each second.
One f ame is made up of two fields. A regular television shows these fields
one a ter the other to create frames,
A still is shown when you pause a moving picture. A frame still is made up
of two alternating fields, so the picture may appear blurred, but overall
quaiitji is high. A field still is not blurred, but it has only half the information
of a frame still so picture quality is lower.
I/P/B
MPEG
Video
1: in
Till,
ms.
acj
P: P i
B;
Tfii
Bidi
Tfiii
Playlj)
If
with
Vid
2, the video compression standard adopted for use with DVD-
codes frames using these 3 picture types,
ra coded picture (1-picture)
is the standard picture and is a complete picture in itself. This
ans it has the best picture quality and is the best to use when
usting the picture,
edictive coded picture (P-picture)
picture is calculated based on past I or P-pictures.
irectionally-predictive coded picture (B-picture)
picture is calculated by comparing past and future I and P-pictures
it has the lowest volume of information. sc
Linear PCM (pulse code modulation)
These are uncompressed digital signals, similar to those found on CDs.
ack control (PBC)
eo CD has playback control, you can select scenes and information
enus (called menu play in these instructions).
Matsushita Electric Industrial Co., ij.td.
W a K i RitA' httrT'/AA/VA/\A/ nanacnnir* nr\ irt/nlnhal/