Panasonic WV-BP100 - Manual (Page 9)

CONNECTIONS
Power Source
■ WV-BP100
Connect the AC Power Cord (8) to a electrical outlet of
120VAC60HZ.
■ WV-BP104
1. A power supply of 24V AC 60 Hz is required.
2. Connect the power cable to the 24V AC In Terminal
(9) on the rear panel of the camera.
24V AC
(19,5V- 28V)
60 Hz .
Video Cable
1. It is recommended to use a video monitor whose
resolution is at least equal to the camera's,
Terminate the camera output with 75-ohm resistor
at the furthest end of its cable run.
It is recommended to use 75-ohm coaxial cable.
Always set the last monitor’s termination switch
to 75 ohms, and set the termination switches
of intermediate monitors to high Impedance (Hi-Z)
position.
Monitor Monitor
Recommended wire gauge sizes for 24V AC line.
Copper wire
size (AWG)
#24
(0.22mm^)
#22
(0.33mm^)
#20
(0.52 mm^)
#18
(0.83mm^)
Length (ft) 314 495 842 1403
of Calbe
(Approx.)
(m) 95 150 255 425
Caution:
To prevent fire or shock hazard, the UL listed wire
VW-1, style 1007 should be used for the cable for
AC 24V Input Terminal.
The maximum extensible coaxial cable length
between the camera and the monitor is shown
in the table 1. Since cable quality varies among
manufactures,
verify video quality before final
installation if maximum lengths are to be used.
- 7 -