Mounting the lens – Panasonic WV-BP100 User Manual
Page 16
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
(5) Both the connector cover and connector should be
positioned to interlock.
N o t e :
Cut off the rib on the connector, when the iris
control cable is too thick and the connector
cover and connector can not be interlocked.
3. Mounting the Lens
When you use the lens other than listed on pages 9,
10,11 and 12, lens mount should be C-mount or special
C-mount
(CS-mount
r-32UN)
and
lens
weight
should
be less than 0.99 lbs. (450g). If not, both the lens and
camera should be secured.
The protrusion of the rear of the lens should be as shown
below.
C-mount :
Less than 7/16“ (11.5 mm)
CS-mount : Less than 1/4* (72 mm)
Caution:
Always set the Flange-back adjusting ring to fully
clockwise (C-mount side) by loosing screws on the
ring before mounting the lens, otherwise the inner
glass and CCD image sensor could be damaged by
the lens.
(1)
Mount the lens by turning it clockwise onto the lens
mount of the camera,
(2)
Connect the lens cable to the Auto Iris Lens
Connector on the camera when an auto iris lens
is used.
(3)
Set the Lens Selection Switch (5) to the proper
position as follows.
- 14 -