Panasonic RS-TR252 - Manual (Page 16)

Before requesting service for this unit, check the chart below for
a possible cause of the problem you are experiencing. Some sim-
pie checks or a minor adjustment on your part may eliminate the
problem and restore proper operation,
if you are in doubt about some of the check points, or if the
remedies indicated in the chart do not solve the problem, refer to
the directory of authorized service centers (enciosed with this
unit) to locate a convenient service center, or consult your
Technics dealer for instructions.
Problem Probable cause(s) Suggested remedy
Tape moves but no sound is
heard. The voiume control of the amplifier is set to its
minimum position.
• Adjust the volume control to the desired level.
The input selector of the amplifier is not set to the
"TAPE" position.
• Set to the "TAPE" position.
Distorted sound. The recording level is too high. • Select the appropriate recording level.
Previousiy recorded sound
has not been erased.
Erase head is dirty. •Clean the head.
Sound output Is hoarse or
unsteady. Heads are dirty. •Clean the heads.
Tape is damaged. •Try operation with a new cassette; if there is no
problem with the new cassette, discard the damaged
cassette.
Poor sound quality
(especially in the high
treble and low bass ranges).
The correct Dolby noise-reduction button is not
set. • Set it to the correct position.
Sound Is low, poor tone,
Intermittent sound noise. Heads, capstan and/or pinch roller are dirty or
tape is damaged.
• Clean the heads, capstan and/or pinch roller, or try a
new cassette.
A “hum” noise Is heard
during tape playback or
recording.
This unit is placed too close to a receiver,
amplifier or tuner.
• Leave as much space as possible between the units,
or place them where there is the least amount of
"hum".
Recording Is not possible. The recording level control is at the "0" position. • Select the appropriate recording level,
One of the tape-to-tape recording-speed
indicators (" X 1 " or " X 2") is rlluminated.
• Switch OFF whichever tape-to-tape recording speed
indicator is illuminated (by pressing the SPEED
button).
TV noise is accidentally
recorded. This unit is placed near a TV. • Try placing this unit further away from a TV.
Matsushita Electric industrial Co., Ltd.
Central P.O. Box 288, Osaka 530-91, Japan
Printed in Singapore
RQT2987-G
H1294J0