Panasonic RS-TR252 - Manual (Page 11)

About the selection of the Dolby NR type
The Dolby NR effect can be obtained by using the same type of
Dolby NR during both recording and playback. Refer to the follow­
ing table when selecting the type (either 8 or C).
Type B
Use this type when the deck on which the tape
will be played back is equipped with only type B
Dolby NR.
Type C
Use this type when the deck on which the tape
will be played back is equipped with type C
Dolby NR. (for example, when this unit is also go­
ing to be used to play back the tape.)
(Refer to “About the Dolby noise-reduction system” on page 7.)
About the recording level adjustment
If the recording level is too high, there will be distortion in the
recorded sounds, and if it is too iow, the hiss noise inherent to
recording tapes will become noticeable.
In order to make high-quality recordings, use the REC LEVEL con­
trol to adjust so that highest values of the Input level indicated by
the ievel meter do not exceed the standard recording level (the
number indicated In parentheses) for the tape being used.
Normal or CrOa tape [ X I (+3)
LiMii mil mil mil iiiii iiiii iiiii
«-ao -16 -10 -* -3 0 no
Riim imi mil imi iiiii iiiii iim
Metal tape (-1-5)
n n n
U U U -
1> |> oaapixY
To make a silent interval
By simply pressing AUTO REC MUTE button, while a recording Is
being made, a silent interval (which is necessary for locating the
beginning of a tune during playback) can be made.
This feature is also convenient for omitting unwanted material
such as commercial messages, etc. during recording,
AUTO REC MUTE
To make a 4-second silent interval
AUTO REC MUTE
pyess AUTO REC MUTE momen­
tarily while a recording is being
made.
A 4-second silent interval will be recorded, and
the unit will automatically be set to the recor­
ding standby mode.
To make a silent interval more than 4
seconds
AUTO REC MUTE Press and hold AUTO REC MUTE
for the necessary number of
seconds while a recording Is being
made.
The unit will change to the recording stand-by
mode when the button is released.
To resume recording
Press either ◄ PLAY or ► PLAY,
corresponding to the side of the
I tape side Indicator which Is lit.
imi mil mil mn
1 - 3 - 3 0 D D
\mii IIIII mil IIIII
Jx1
- 8 - 3 0 D O + 8
U
E 3 -
Tape side indicator« or »
11