Panasonic CT-3268S - Manual (Page 18)

Multi Button (for CT-3268S)
The MULTI button can be programmed to operate up
to 6 Remote function buttons at the same time.
For Example:
TV Power/On, VCR Power/On (selected
brands) can be operated at the same time with one press
of the MULTI button.
Procedure
1. First program the Remote for the selected VCR
Infrared access code. Confirm that the Remote
Control is compatible with the equipment.
Face the Remote Control transmitter away from all
equipment remote sensors.
Press and hold down the Remote TV Power button,
then press and hold down the MULTI button at the
same time. Release buttons (All previous commands
will be erased.)
POWER MULTI
Special Functions
(cont.)
2 .
3.
PRESS SIMULTANEOUSLY
4. Press a maximum of 6 Function buttons on the
Remote.
Each button you press is equal to one function. If six
Remote button functions are entered, all will register
in the MULTI button memory in the sequence entered.
When less than six Remote button functions are
entered, press the MULTI button to end the program
mode. (Waiting more than 30 seconds without
pressing another button will also end the program
mode.)
The following is an example of Remote functions that
can be programmed into the MULTI button.
- TV Power - For turning TV ON and OFF,
- VCR Power - For turning VCR ON and OFF (selected
brands after programming it’s Infrared access code, if
necessary).
Both can be turned ON or OFF with one press of the
MULTI button.
POWER VCR POWER
MULTI
To delete entered functions - Repeat step 3. Now
you can enter from one to six different Remote
functions.
NOTE: You can also program the MULTI button to perform
most individual Remote Control button functions.
Buttons which continuously perform a function as
long as pressed (Volume Up/Down, Channel
Up/Down, etc.) cannot be programmed. Only
those buttons which perform a function when
initially pressed (Power On/Off, Mute, Direct
Channel Entry, etc.) can be programmed.
Cable Power Button (for CT-3268S)
CABLE
POWER
The on the Remote Control has been designed
to operate selected brands of Cable Television Converter
boxes. The proper cable television converter box infrared
code must be obtained prior to use. (Please refer to
Programming the Universal Remote for programming
instructions.) The Remote Control TVA/CR/CABLE switch
should be in the CABLE position.
NOTE: The A or ^ on the Remote may be used for
selecting Cable Converter box channels.
PIP (Picture in Picture) Button
This feature allows the viewer to monitor one channel
program while watching another. The monitored source
(PIP) must be a different video source (such as a VCR)
when connected to the input jacks.
• When the Main Picture is in Video mode with no signal,
the PIP will not operate properly.
PIP Operation
1. Turn VCR ON and select a desired channel.
2. Press the TV Mode Selection button to operate TV
Remote functions, if necessary (some models).
3. Press the PIP button (set must be ON). The PIP frame
wilt appear at the position it was last displayed. The
Main Picture Video Source and PIP Video Source will
display on screen momentarily. Audio will be that of
Main Picture.
4. Press the PIP button again to cancel PICTURE IN
PICTURE feature (if desired).
NOTE: For PIP Video source connection, refer to the PIP
Operation Using VCR As second Tuner section.
- 1 8 -